Auto-Calibrator
The Auto-Calibrator verifies and calibrates current and voltage with a click of a button. The powerful Auto-Calibrator software lets you connect as many channels as you wish, with appropriate cable sets, and calibrate with virtually no other intervention. Upon completion a calibration verification report is available and can be saved or printed.
 

Uninterruptible Power Supply
Test systems are designed to detect power outages and avoid losing any data when a UPS is used on the logic power supplies and tester PC. System can be user configured to restart suspended test when power is restored or wait for user intervention depending on the length of the power outage.
 

Interface Shelves
Shelves for the cabinet's interface are available. Shelves reduce the cabling needed by allowing you to test the devices at the tester interface.
 

Adjustable Cell Holders
The adjustable cylindrical cell holder may be mounted on the cabinet's interface or remotely. The cell holder is available in blocks of eight and adjustable from button to 18650 cell sizes.
 

Coin/Button Cell Holder
The coin/button cell holder is adjustable for a variety of cell diameters. With a thumb screw terminal on one end and a spring loaded terminal on the other it makes perfect contact every time. These cell holders are mounted on a circuit board and plug-in directly to the cabinet's interface.
 

Molded Kelvin Cell Holder
The first and only true four-wire cell holders are available in a variety of sizes including: AAA, AA, C, D, and 9 Volt. These cell holders provide the most accurate measurements at the cell. Cell holders are mounted on a circuit board with either power pole or phoenix connectors.
 

Interface Cables
Cables are Four-wire terminated with power-pole for tester interface, and your choice of alligator clips, spade or ring lugs, banana plugs, or kelvin clips for user interface.